DIY Balustrade Wire - Ball System

DIY Ball & Socket adjustable balustrade wire infill. A4 / AISI 316 stainless steel with a highly polished finish.

Included in this kit:

• 2x flat mounting sockets with fixing screws.
• 1x DIY swageless compression fitting ball terminal.
• 1x swage adjuster with ball terminal with set length of 4mm 1x19 stainless steel wire. (Pre-swaged)

This is a very simple to use system for those interested in balustrade runs. It requires no specialised tools and is suitable for angles up to 35 degrees.

Our flat mounted sockets provide a sleek finish and attachment to you timber posts, flat steel posts or masonry surfaces. The swageless ball end allows for a simple and stunning finish, with no specialised tools required.

Our Balustrade Wire - Ball System kit is available in 1meter, 2meter, 5meter, 7.5meter and 10 meter runs, as seen in the table below.